FE-FC Holden Discussion Forum
November 25, 2024, 12:12:55 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > Modification Help (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Clutch slave cylinder
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Clutch slave cylinder  (Read 2467 times)
BigAlFC
Junior Member
**
Offline Offline

Posts: 25


View Profile
« on: June 22, 2017, 10:37:50 PM »
0
I have a Aussie 4 speed on my FC with the clutch slave cylinder my problem is that the shaft that comes out of the slave has to be on an angle to fit in the hole on the gear box fork arm is this normal
Logged
Errol62
Guru
*****
Offline Offline

Posts: 1189


View Profile
« Reply #1 on: June 23, 2017, 08:26:46 AM »
0
Should be parallel to slave cylinder bore. Been a long time but vaguely recall drilling a fresh hole on the lever maybe. I had a cast iron adapter bracket which snapped and  I replaced with a cast aluminium Hadfield one. It kept the slave fairly close to the bell housing. A picture would help.


Sent from my iPhone using Tapatalk
Logged
BigAlFC
Junior Member
**
Offline Offline

Posts: 25


View Profile
« Reply #2 on: June 23, 2017, 11:16:09 AM »
0
I will send a photo as soon as I work out how
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.027 seconds with 18 queries.