philby26
|
|
« on: August 20, 2009, 10:14:47 PM » |
0
|
Hi guys can any one help me with some heater installation instructions i have a round preslite outoheat heater mainly the mounting brackets and where the hoses go threw the fire wall etc i also want to hook up reverse light switch that i have it mounts to the steering column near gear linkages cheers Phil
|
|
|
Logged
|
|
|
|
TTV6FC
|
|
« Reply #1 on: August 20, 2009, 10:16:34 PM » |
0
|
Yes advice would be good as I am also about to install a similar heater to the Black FC....
|
|
|
Logged
|
Run your fingers over my Holden and I'll run my Holden over your fingers!!!!
|
|
|
collecta
|
|
« Reply #2 on: August 21, 2009, 12:04:07 AM » |
0
|
Try accessory of the week section im sure i remember seeing fitting instruction sheet attached in the heater section. cheers Scott
|
|
|
Logged
|
i collect old holdens coz they never die!
|
|
|
mcl1959
|
|
« Reply #3 on: August 23, 2009, 04:55:44 PM » |
0
|
The original fitting instructions are there and for the life of me I don't know why they were done that way. I have never used this method when fitting a heater because the nut looks so bad sitting on top of the crest pressing. I suggest moving the whole thing slightly to the left so that all the nuts are on a level surface. See no 44
Be careful with reverse light switches - lots of ebay sellers claim to sell switches with 4 small holes which will fit FE to HR - NOT TRUE - FB to HR have 4 matching small holes in the column where the switch is mounted. The FE FC switch has a special bracket which mounts to the gear lever bracket bolts - Once again check in accessory of the week for the right picture. See no 17
Ken
|
|
|
Logged
|
|
|
|
philby26
|
|
« Reply #4 on: August 23, 2009, 09:17:48 PM » |
0
|
Thanks Ken How do i get to see the accessory of the week I'm not in a car club and when i type it in it says its been moved to some site and can only view if in a club
thanks Phil
|
|
|
Logged
|
|
|
|
mcl1959
|
|
« Reply #5 on: August 24, 2009, 06:47:06 PM » |
0
|
I think the only way to view is to join a club
Ken
|
|
|
Logged
|
|
|
|
TTV6FC
|
|
« Reply #6 on: August 24, 2009, 07:34:07 PM » |
0
|
I've got the same problem Phil,can't see it and need to know....
|
|
|
Logged
|
Run your fingers over my Holden and I'll run my Holden over your fingers!!!!
|
|
|
pedro
qld-club
Guru
Offline
Model: FC
Posts: 1683
If you haven't grown up by 50, you don't have to.
|
|
« Reply #7 on: August 24, 2009, 07:45:25 PM » |
0
|
Maybe somebody who is a club member or one of the moderators could copy it and post it here for you, try asking Stinky nicely . Pedro
|
|
|
Logged
|
I love animals - they taste great
F4+
|
|
|
Glenn 'Stinky' Stankevicius
|
|
« Reply #8 on: August 25, 2009, 02:48:57 PM » |
0
|
Sorry guys, no can do. I know I'll cop stick for it, but at the end of the day it is the clubs that pay for the entire site including the Forum. To keep the site running the clubs need to pay, for the clubs to pay for the site they need members. As a perk, the members get "exclusive" content.
|
|
|
Logged
|
|
|
|
zulu
nsw-club
Guru
Online
Model: FE and FC
Posts: 1863
Old Boonah Ambo
|
|
« Reply #9 on: August 25, 2009, 03:20:31 PM » |
0
|
I reckon thats fair enough, it's only $35 ? a year to support the clubs, and as it is you get a heap of help even without being financial.
Some of the benefits you get is "For Sale to Club Members Only" section (I have purchased at least 2 cars through this) and Alex's "Accessory of the Week" usually with the fitting instructions
There is no pressure to go to any club meetings or runs, some members live too far away & some members don't have their cars completed
But for a few dollars, I reckon it's well worth it
Gary
|
|
|
Logged
|
|
|
|
TTV6FC
|
|
« Reply #10 on: August 25, 2009, 07:14:42 PM » |
0
|
And that's all fair enough too.I have full intentions of joining a club but firstly would like to have a vehicle to present to the club and I currently have so much going on that I would not have any spare time to be a participant.I don't want to be a club member that ums and arrs every time something is asked of them just because I don't currently have the time.I would prefer to be an active part of a club.These are my opinions only.I accept rules are rules and therefore will just make an educated decision on how to install my heater and hope I don't F##K it up.Cheers,Jamie.
|
|
|
Logged
|
Run your fingers over my Holden and I'll run my Holden over your fingers!!!!
|
|
|
pedro
qld-club
Guru
Offline
Model: FC
Posts: 1683
If you haven't grown up by 50, you don't have to.
|
|
« Reply #11 on: August 25, 2009, 07:46:07 PM » |
0
|
Sorry guys, no can do. I know I'll cop stick for it, but at the end of the day it is the clubs that pay for the entire site including the Forum. To keep the site running the clubs need to pay, for the clubs to pay for the site they need members. As a perk, the members get "exclusive" content. I agree, support your local club, Just waiting for my membership to arrive , Hey Jaime have you tried typing what you want into google, you never know what results you'll get. Pedro
|
|
|
Logged
|
I love animals - they taste great
F4+
|
|
|
philby26
|
|
« Reply #12 on: August 25, 2009, 09:33:45 PM » |
0
|
thanks guys i will look into the car clubs here in tassie is there a particular club i need ? cheers Phil
|
|
|
Logged
|
|
|
|
Ol_Girl_58
tas-club
Senior Member
Offline
Model: FC
Posts: 945
getting there...
|
|
« Reply #13 on: August 25, 2009, 10:12:59 PM » |
0
|
Philby,
One of the clubs we have down here is the Early Holden Car Club of Tasmania, which has members from around the state. We are based in Hobart, but we have club runs to various parts of the state in order to catch up with our members. Weddo on this forum is the club president. PM him for details/contact numbers if you are keen in joining.
I am certain that you would need to be a member of this club in order to be an FE-FC Holden forum member, as this forum is kind of like an amalgamation of FE-FC Holden/early Holden specific clubs.
Kind regards,
Josh
Ol_Girl_58
|
|
|
Logged
|
|
|
|
mcl1959
|
|
« Reply #14 on: August 26, 2009, 06:32:06 PM » |
0
|
Phil, any club will do - the Vic club has members in NSW SA TAS and in Ireland Ken
|
|
|
Logged
|
|
|
|
|