WIRE WHEEL TRIMS

[zulu]

Giday all, I am looking for the wire wheel trims in the attached picture.
CASH REWARD, dead or alive any condition considered, reply with PM, here or email to botswana@bigpond.com all help appreciated.
Will take this opportunity to thank member customFC for posting pic of last wheel trims I was looking for, and found thanks to member ACE.
Regards, Gary

[fc_ute]

does the standard fc hubcap still fit in the middle or do you just have the wire part and leave your nuts exposed? have seen this type of cap before but the hole in the middle is bigger

[zulu]

Exposed nuts? no :o no :o no, the hub cap remains in place, then the wheel trim fits over it, thus framing the hub cap.
Cheers

[59er]

Gazza, I saw some on" MY" car.Sorry mate but I like em too much . Cost about $350.00 to get them cleaned up and rechromed at Bluechrome. They did a good job. Good luck buddy. Kev..

[zulu]

Hi Kev, Only recently saw your cheeky reply  :'( well I now have 2, so cop that, if you see any more, you know where to send em.
Regards, Gary

[Glenn 'Stinky' Stankevicius]

I was at a bloke's place today that has 2 of these trims, I didn't have a close look, but I am sure the dish was the opposite to the photo. Anyway, he reckons he will be listing them on ebay soon. If anyone wants any more info let me know and I will try to find out.

[zulu]

Hey Stinky, Were they 13 inch? I have seen them in both 14 & 15 inch since I have been looking. Any chance of a pic & or his phone no? thanks for keeping a lookout.
Regards, Gary

[FC0058]

Zulu
Thought I had found one for you. check it out any way but does not look the same.

http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=2473881880&category=29700

[zulu]

Yep, close Jim but no banana, thanks for keeping an eye out, have you ripped those doors off yet?
Gary

[Glenn 'Stinky' Stankevicius]

Thanks Jim for the link,

Gary, they are the ones I am talking about, obviously not the right ones, oh well.

[zulu]

No Stinky, As per the original pic I posted, the ones I am looking for are a wire trim, not any kind of stamped trim, thanks anyhow.
Regards, Gary

[FC0058]

Hi Gary
Found this on eBay and immediately thought of you. It took me a while to find this post but here you go.

Cheers Jim

http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=4601307344&ssPageName=ADME:B:SS:AU:1

[zulu]

Hey Jim, Thems the ones allright, i'll send him a message to see if he has any in 13 inch.
Thanks mate, Regards, Gary

[COL58FE]

g'day gary,
                 got two 13inch one's,but
chrome unknown as they've been
painted silver(no spinner's).not sure
on value make me a fair offer and
there your's,they are the one's off
this fc ;D ;D ;D

                       cheer's col.

[zulu]

G'Day Col, Bit hard to make them out in that picture. Do they look like the one in the picture at the beginning of this thread? if yes, are they straight?
Regards, Gary

[COL58FE]

g'day gary,
                 they do have some minor
dent's in them as per pic's,there no
use to me as i'am using US RACER'S.
any they seem to look the same
except it appear's the outter trim's
might be missing compared to the
one in your pic.
              cheer's col.

[zulu]

Col,They are similar but not the same, I will pm you re cost.
Regards, Gary

[COL58FE]

these dress rim's on now sold. ;)