FE-FC Holden Discussion Forum
November 25, 2024, 02:18:46 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > Restoration Help (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Ute rear shocker covers
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Ute rear shocker covers  (Read 2232 times)
Norm
Newbie
*
Offline Offline

Posts: 5


View Profile
« on: January 19, 2018, 03:07:33 AM »
0
Can anyone help me?
 I after the size of the two plates that are use to cover the access holes for the rear shockers upper mounts on a FC ute.
Logged
hsv-001
Senior Member
****
Offline Offline

Posts: 909


View Profile
« Reply #1 on: January 20, 2018, 08:39:48 AM »
0
If they are [fairly sure] the same as the van then you are looking at square plates around 10# 112mm [4 1/2"] radiused corners close to the size of a 5cent piece with a 1/8" drilled centre and CSK screws if that helps .
Logged
Norm
Newbie
*
Offline Offline

Posts: 5


View Profile
« Reply #2 on: January 20, 2018, 09:45:28 AM »
0
Thanks for the help!
I thought they were around that size, but I wanted to them to be correct!
Thanks again!
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.026 seconds with 20 queries.