FE-FC Holden Discussion Forum
November 27, 2024, 12:49:29 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > General > General Board (Moderators: RET, Glenn 'Stinky' Stankevicius) > baby moon caps
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: baby moon caps  (Read 2308 times)
snuff69
Senior Member
****
Offline Offline

Model: FE
Posts: 256



View Profile
« on: October 09, 2009, 02:20:26 AM »
0
g'day everyone anyone know where I can buy a set of baby moon caps to suit 13" wheels   thanks Dave
Logged
Glenn 'Stinky' Stankevicius
Moderator
Guru
*****
Offline Offline

Model: FE and FC
Posts: 5135


Willaston, South Australia


Glenn.Stankevicius
View Profile
« Reply #1 on: October 09, 2009, 08:50:40 AM »
0
I got a set from Hyway Truck Supplies (they are National) but they were a loose fit. A bit of weld on the existing hub cap lugs and I never had a problem with them.

exact page for the caps - http://www.hyway-store.com/index.php?target=categories&category_id=883
Logged
http://forum.fefcholden.club/index.php/topic,18001.0.html
jack_fc
Senior Member
****
Offline Offline

Model: FC
Posts: 745


SouthWest Coast, Victoria


View Profile
« Reply #2 on: October 09, 2009, 09:21:16 AM »
0

I got a set of 14" caps from Autobarn; they had to order them in - they may be able to supply 13"also?
Cost around $65 for set of 4 about 3 years ago...
cheers jack
Logged
"when I was a young lout, it was all about sex, drugs, rock'n'roll, beer and hot Holdens. Now I'm an old lout, but I've still got the old Holdens and beer..."
snuff69
Senior Member
****
Offline Offline

Model: FE
Posts: 256



View Profile
« Reply #3 on: October 09, 2009, 10:15:07 PM »
0
thanks guys   I found some on ebay, the mob selling them say they have 2 sizes  10 1/2" and  9 5/32"  OD  I asked them if they knew if they would fit but all they told me was these outside measurements. Any ideas?  I measured an original hubcap and they are about        9  1/8" on the inside.   Dave
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.033 seconds with 20 queries.