Hi Guys,
just thought I'd share the solution I found to replacing the Bailey Channel in my FC (I hope I'm not trying to teach others how to suck eggs here, but I haven't seen too much about Bailey Channel refits on this discussion page)
I know this is not original stuff and that some people are particular about that....but for those a little less particular, I obtained these mouldings off the shelf from my local Rare Spares stockist.
I found two different section mouldings to do the job.
The first one, which is wider, I used to go in the channel pressed into the door frame, cutting a "V" out of each side to form a mitre where the right angle is required at the top of each door. I found that the "tails" on the back of this moulding served to keep it anchored in the channel in the door and when cut to length, it stayed in place well without adhesive. This moulding is the standard replacement moulding for "HQ" window channel.
When I tried to see how I could make this one fit the division channel, I experimented with cutting the "tails" off the moulding...without success. Eventually, I went back to the Rare Spares stockist (a local panelbeater shop) and showed him how it wouldn't fit...then he came up with the second, smaller moulding.
The second one is much smaller in cross section and more "square" than "flared". It was a tight fit in the division channel but I made it seat better by using the glass to press it "home". At first, the glass looked like it might be too tight to freely move up and down with the regulator mechanism....so I used spray-on silicone lubricant on the felt to let it "slip" more easily.....worked a treat!!
Hope this helps someone searching for a non-original but neat solution to Bailey Channel refit.....the stuff was only about $7 a metre.....
Brad
