 Show Posts
|
|
Pages: [1]
|
|
2
|
Technical Board / Restoration Help / Re: Battery position
|
on: February 10, 2014, 06:49:23 AM
|
|
Hi Ken
Thanks for your reply
I have seen many photos on different cars with battery in both positions ,with the positive terminal towards the starter motor
Regards Ted
|
|
|
|
|
3
|
Technical Board / Restoration Help / Battery position
|
on: February 09, 2014, 09:27:17 PM
|
|
HI Does anyone know which is the correct position of the battery in stock fe
Do the terminals sit on the engine side near the battery holder or are they on the lh inner guard side
Thanks for any advise
Ted
|
|
|
|
|
7
|
For Sale and Wanted / Parts Wanted / LUCAS REGULATOR
|
on: October 13, 2013, 11:02:44 AM
|
|
Hi
Does anyone have a original lucas regulator for fe series in working condition with clip for fuse holder in excellent condition
Regards Ted
|
|
|
|
|
11
|
For Sale and Wanted / Parts Wanted / fe vacuum wiper switch and chrome knob
|
on: August 23, 2013, 08:59:54 PM
|
|
Hi
I am looking for a wiper switch and chrome knob for a vacuum wiper motor on my Fe. Should come with the operation cable.
I need a good vacuum valve on the back for the windscreen washer system hopefully all in excellent condition
Kindest regards
Ted
|
|
|
|
|
13
|
Technical Board / General Technical / Re: ignition timing
|
on: August 17, 2013, 09:35:29 PM
|
|
Hi I have found the quickest way is to remove no 1 spark plug and disconnect the coil wire so the engine wont start."Take note of where the no 1 spark wire is located on the distributer cap .Put your finger over the spark plug hole and get some to turn the engine over .Every time the compression pushes your finger away from the spark plug hole (causing a popping noise) the rotor button should be at the no 1 position on the distributor /rotor cap
Regards Ted
|
|
|
|
|
16
|
Technical Board / General Technical / Flexible oil coupling
|
on: August 17, 2013, 08:04:20 PM
|
|
Hi there ,
does anybody have a picture of what the flexible coupling looks like,that is supposed to be fitted between the copper line and the wilsonia gauge oil fitting
Regards Ted
|
|
|
|
|
18
|
Technical Board / Restoration Help / Re: Rear Parcel Shelf Board Help
|
on: October 17, 2009, 03:55:05 PM
|
|
Dear Alex
Charlie is doing really well (I think he misses the FE 'a lot')
As with the car I left her alone for a couple of years (alas poor Fe) but will be back on the road in a couple of months (My son has asked to have the car for his wedding so I have been working on it the last few months to finish her.I have asked dad to drive the car for me (He's really excited about the thought.)
Hope to take some pictures then and post them in the forum
Thanks for your interest .
Many Regards Ted
|
|
|
|
|
20
|
Technical Board / Restoration Help / Rear Parcel Shelf Board Help
|
on: October 05, 2009, 01:24:51 PM
|
|
Could anyone please inform me if you can still purchase the rear parcel shelf board under the rear window as mine has deteriorated .Or does anyone have a template so I can make a correct shape.
Kindest Regards Ted
|
|
|
|
|
