FE-FC Holden Discussion Forum
April 19, 2024, 08:29:41 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > General Technical (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > FC rear suspension
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: FC rear suspension  (Read 3286 times)
PeteR
Newbie
*
Offline Offline

Posts: 20


ampmobile


View Profile WWW
« on: March 25, 2002, 05:24:32 AM »
0
Can someone tell me if the front spring hanger bolt is threaded into the holding plate I am having trouble removing it
Thanks, Huh
          Peter
Logged
mcl1959
vic-club
Guru
*****
Offline Offline

Posts: 6155


FE's rule


View Profile
« Reply #1 on: March 25, 2002, 05:52:04 AM »
0
Peter,  no its not threaded, but these things get VERY tight after a few years.  The best way to get them out is with a long heavy drift with a big hammer.
Dont worry about damaging them getting them out, because they are usually no good anyway due to wear and rust on the shaft.

Repro ones are available from Rare Spares

Ken
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.025 seconds with 19 queries.