FE-FC Holden Discussion Forum
March 30, 2024, 12:06:58 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
Pages: [1]   Go Down
  Add bookmark  |  Print  
Author Topic: firing up the project  (Read 4326 times)
Ed
Guru
*****
Offline Offline

Model: FE
Posts: 3311



Ed74mnd
View Profile
« on: December 14, 2001, 01:00:26 AM »
0

Hi, I would like to start up my motor (carbed 308), however have not yet installed the entire wiring.

Could somebody advise me of the most basic wiring set up req'd to start and run a motor.

most importantly the starter circuit without killing my expensive starter motor.

thanks

Logged

in the shed
craiga
Guest
« Reply #1 on: December 14, 2001, 09:33:08 PM »
0

Hi Ed,

Following is required:

Battery -VE to Engine Block using 100AMP or greater cable
Battery +VE to Starter using 100AMP or greater cable

Battery +VE to Starter Solenoid connector (usually a 'spade' type connector) through a switch. This is your ignition switch and when turned on will cause the starter solenoid to engage and the starter to turn over the engine, so make sure you can access it easily as you will need to turn it off when the engine fires. Wink

Battery +VE to Coil +VE

Coil -VE to distributor (points) If you have an electronic ignition it may be slightly different so be careful as you may damage the module if connected incorrectly.

To run the engine for a short period of time you don't need to connect the alternator, just use a fully charged battery and you will get 20 minutes or more running.  Shocked

If you need I can send a basic diagram.

Have fun Grin


Remember no warranty with this info Tongue Tongue

Cheers,

Craig.
Logged
Ed
Guru
*****
Offline Offline

Model: FE
Posts: 3311



Ed74mnd
View Profile
« Reply #2 on: December 14, 2001, 10:18:09 PM »
0

Thanks Craig  Grin
Logged

in the shed
ACE
Guru
*****
Offline Offline

Posts: 1253


DOH!!!!!!!!!!!! !!!!


View Profile
« Reply #3 on: December 15, 2001, 04:23:03 AM »
0

 ;)HI ED
I WOULD ALSO CONNECT UP A OIL AND TEMP GUAGE.
ALSO YOU MAY NEED A EXTERNAL BALLAST RESISTER
FOR THE COIL.
REGARDS ACE.
P.S DONT FORGET TO PRIME THE OIL PUMP BEFORE STARTING.
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.024 seconds with 19 queries.