FE-FC Holden Discussion Forum
November 15, 2024, 04:25:18 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > Restoration Help (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Bumper Mounts on rear mudgaurds
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Bumper Mounts on rear mudgaurds  (Read 1723 times)
KFH
qld-club
Senior Member
****
Offline Offline

Model: FC
Posts: 683



View Profile
« on: May 16, 2010, 09:31:23 PM »
0
Can anybody tell me if the flat area where the bolts and rubbers sit in the rear guards for holding on the bumper are parallel with the body or are they a little off parallel?  The surface on both sides of mine are not quite parallel.  From memory, without going out to look, thay are a little further in at the front than the rear.  My thoughts are that the outer ends of the bumper may have had a bit of a nudge.

Keith
Logged
I was born with nothing and still have most of it left
KFH
qld-club
Senior Member
****
Offline Offline

Model: FC
Posts: 683



View Profile
« Reply #1 on: May 22, 2010, 09:15:27 PM »
0
To explain myself a little better I have attached a photo.  Thee question is:  The area around the bolt hole - should it be recessed like shown in the picture or should the area around the bolt hole be flat.





Keith
Logged
I was born with nothing and still have most of it left
FC_fer_me
vic-club
Full Member
***
Offline Offline

Posts: 226


baby boomers luv FC's


View Profile
« Reply #2 on: May 22, 2010, 09:42:28 PM »
0
Hello Keith, had a look at both my cars and they are all flat. A bit of hammer and dolly work should fix yours. Cheers, Jack
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.033 seconds with 19 queries.