Petrol Flow

[red_devil]

Hi guys, have had the car parked for five years, so dropped the dirty fuel out of the tank. I disconnected the fuel line at the pump and blew the old fuel down the line back to the tank and out. For some reason we now cant get fuel to flow from the tank even after putting 40 ltr of fuel in, any ideas why no flow. Fitted new fuel pump, had car running with jerry can but not pumping fuel from tank, any ideas.
Regards
Red Devil.

[mcl1959]

I bet the braided rubber hose you disconnected is now broken inside. It will be now sucking air through the holes rather than petrol from the tank.
Remove the hose and check for leaks.

Ken

[red_devil]

Thanks Ken will explore and advise.
Regards
John

[pedro]

Could have sucked up a bit of crap from the bottom of the tank and blocked the line, if you've got good lungs try disconnecting the hose from the fuel pump and then blowing air into the filler hole to see if any fuel comes through, i bought a car once that ran beautifully around town but would die every few k's in the 100 kph. zone, replaced the carby then the fuel pump. had me stuffed ??? until i found a little beetle carcass stuck in the brass fitting on the tank.
               Pedro

[red_devil]

Thanks Pedro working on a process of elimination along that line.
Thanks for posting, it helps.
Regards
John
Red Devil

[red_devil]

Guys where is the best place in Sydney to buy the flexible fuel line from the steel fuel line to the petrol pump.
Regards
Red_Devil

[stapla]

I used pirtek to get a braided fuel hose made up.  I think they needed some of the old fittings.

[red_devil]

good call, that would be a premium way to do it once and right.
Regards
Red_Devil

[mcl1959]

The easiest way if not seeking originality is to use the fitting from a red motor fuel pump and replace the braided line with rubber fuel hose - make sure you use hose clamps each end.

Ken

[FC427]

good call, that would be a premium way to do it once and right.
Regards
Red_Devil

The Premium way would be using AN fittings with -6 braided stainless hose it lasts for many many many years .no problems getting a fitting for the fuel pump but would need a male -6  fitting silver soldered on the end of the fuel line ....Earl's ,Russel or Speedflow can supply all that is needed ...........FC427.......

[red_devil]

Great guys those are great solutions.
Thanks for the direction, love this forum.
John

[red_devil]

Hi Stapla your Pirtek suggestion got us over the line, $15.00 bolted on started first go. Love this Forum, thank you to all that gave guidance your time and effort is so appreciated.
Merry Christmas to all
Warmest Regards
John
Red_Devil.