News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

Fuel Gauge stuck on Full

Started by NES304, June 07, 2009, 03:22:12 PM

Previous topic - Next topic

NES304

This an earthing issue?
Goes to Empty when car off....



yaapeet11

Be nice to hear that it is an easy fix as I have exactly the same problem! :-\

steamman

Sounds like an earth issue to me, i used to have an fc in the 70's that had a fuel guage that would go to full when you filled it up and it would stay there untill you had about 20 miles to empty,at that time it would start to move and bounce and head in the  general direction of empty fast.
Cheers
Deano.
FE and FC"S rule.

NES304

Thats what I am thinking but its all the way to the right no matter what unless I cut power. I can't work out where the bad contact is though. thought it was the brown wire so tried to clean it without ripping everything out.



zulu

Let us know how you go with it Nes, mines the same in the wagon, goes to full when you turn the key and stays there till you turn it off  >:(
Gary

waynos

i havent even hooked my sender up yet and it goes to full.check your sender wire hasn't fallen off,or earthing to the body somewhere.
The grinder is mightier than the sword.

brett_f

Guys,
There are a couple of things that could do this. Make sure the plastic is in place on the two post connectors on the back of the gauge. The conector post marked sender should not "earth" or touch the gauge metal. (neither should the power).This would create the condition that the guage reads full.It could also be faulty sender units. This could be tested by removing the sender wire on the gauge.If it goes back to empty then the sender is faulty. Waynos if your gauge reads full without the sender wire connected, then i believe you have the above condition (terminal post touching gauge metal) or simply a faulty gauge.
Regards brett

fcv85l

i think you will find early holden fuel gauges read high when open circuit IE crook sender or poor connection between sender and gauge as they are not a bi metal type gauge,earth the sender wire at tank and see if it returns to empty,also run a test earth at a known test point directly to the sender housing to ascertain sender earth,remember the gauge earths through the cluster housing