News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

King Pin Installation

Started by plumer46, November 01, 2008, 02:27:38 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

plumer46

November 01, 2008, 02:27:38 PM
Hi

I am installing the front suspension on my FE Ute, I am not sure which way the King Pins and bolts go, does the bottom nut on the king pin and grease nipples face to front or rear.

I am not sure what is Left and Right re the King Pin assemblies, could someone assist me and possibly a picture of an assemblied front end, the manual does not clearly state the difference.

Regards

John G ???

mcl1959

#1
November 01, 2008, 05:24:02 PM
John - page 54 of the manual shows the correct way to install all parts. The king pin is installed with its grease nipples to the front. The lower bolt is inserted from the front with the nut going on the back. The upper bolt is inserted from the back with the nut on the front.

Hope this helps

Ken
Print
Go Up Pages1
User actions