News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

FC wheel cylinders

Started by Penguin, August 31, 2008, 09:48:54 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Penguin

August 31, 2008, 09:48:54 PM
I need to replace the wheel cylinders on my FC, original brakes. I found I can purchase EH wheel cylinders considerably cheaper than FC units. Is it possible to fit the eh cylinders to fc brakes?
Thanks in advance, Ben.

Papa Smurf

#1
September 03, 2008, 10:03:35 AM
Would say no without other modifications as front FX - EK cylinder bore is 1-3/16 inch where as the EJ - EH are 1 inch & rear FB - EK are 1 inch & EJ - HR 13/16 inch.
Best check with a brake repairer as your brakes play a very important part in stopping a vehilce.

Papa Smurf

#2
September 03, 2008, 11:59:08 AM
Quoterear FB - EK are 1 inch & EJ - HR 13/16 inch

What I should of said was rear FX - FC 1 1/16 inch & EJ - HR 13/16 inch

Penguin

#3
September 03, 2008, 05:40:41 PM
Thanks Lizard

I958GM

#4
September 20, 2008, 05:43:15 PM
Dont know if this helps, but l have a complete rear end with near new cylinders, brakes,machined drums, axles and diff for $150.00 just taken out of my FC if your interested.
Print
Go Up Pages1
User actions