FC Ute

[MY UTE]

Hi Guys, i have just bought an FC ute and it has a 161 motor coupled to the old grey motor 3 speed box, i would like to fit an aussie 4 speed, i will have bucket seats so shifter position should be ok, i was wondering what do i need to do to fit this, also i would like to locate a twin carb manifold and carbs to fit, as well as perhaps putting disc brakes on, i know about the HR front end conversion , but was wondering what other brake system can be used if any, all help will be appreciated.

[Glenn 'Stinky' Stankevicius]

The trans tunnel will most likely need to be modified or at the very least massaged a bit.
Trading Post, Oztion, Holden Forums and dare I say ebay are your best bets for locating carbs and manifolds, some manifolds can be bought new from places like Hardiman/Redline, Xtreme Carby services may sell carbs as well as their changeover service.
Not sure about disc brakes to FC front-ends, if you are keeping the 161 and don't drive like a maniac the drums should be OK.

[mcl1959]

There is a CRS disc brake conversion for FC front end but I wouldn't use it on my own car. Other options depend on your skill level and finances - Torana front ends can be done and there are some big dollar custom made independant front ends available as well. Best value for money, you cant beat a HR front end. ;)

Apart from tunnel mods, you will need a custom length tailshaft and a half chassis kit to support the rear of the gearbox from. Make sure your Aussie box is pre Commodore with hydraulic clutch.

Ken

[JSM]

PM sent

Cheers
John