FC/FE front cross member

[brett_f]

Wanted bare front cross member any condition. Need it for the mounting plates only as i am doing a conversion. I am located in melbourne so local would be good
Regards Brett

[trevwood]

would an fb one do?

[NES304]

there are no engine mounts on the cross, there is one on the outrigger, is that the one you want

[brett_f]

Thanks guys for your replies. As for the FB cross member i am not sure if the mounting brackets are either the same or same positions as the FC FE. Can anyone verify this. The crossmember i am after is the main one where engine mounts normally go on red motor vehicles. In other words the member that holds the upper and lower wish bones.Regards Brett

[mcl1959]

Brett, if it is just the mounting plates you need then a FB one will be fine as the mounts are the same as FC.  In fact the mounts are the same from FE right up to HR.  However the crossmember is a different shape from FB onwards so would be no good if you want to use part of the crossmember for your setup.
Ken

[brett_f]

Thanks ken your full of knowledge.Therefore i am now looking for a bare cross member from FB to HR as i only want the mounting plates.These are being transfered to a torana front end as my original front end had been reconditioned and it would be ashame to cut this one up.
Regards brett
By the way Ken i haven't forgot about the trims its been because i have been interstate.Will call you soon.

[trevwood]

In that case I have an fb one if you want, and Im in melbourne! Call me on 0414 557 622 thanks Trev.

[brett_f]

Thanks guys for your help. i have recieved a donor cross member from trev. i have also had my commodore rear end with trailing arms fitted to my fc and looks fantastic. any questions i would be more than happy to answer. Trev has also sighted this conversion.