SCUFF PLATES ???

[Blown_FC]

Can anyone tell me if FB-EK Scuff Plates fit FE-FC bodies ?

I'm talking the metal plates that run along the bottom of the body where the doors close and hold down the carpet and body rubber.

Cheers

Mark

[COL58FE]

G'day Mark,
                  yes mate they do and will fit perfectlly.
                                                               cheer's col.

[TorqueFC]

yes i believe they do fit, but they are slightly a diffferent shape!

[COL58FE]

torquefc,
             i think you better check on
that one as they all have the same
sill's and floor pan's,so i can't see
them being different.except on the fe
they are flat on the top surface other
than that they are the same.
                                     cheer's col. ;)

[4hammers]

Hi Guys.
Torque is right. They are all slightly different, but they all fit. The FE is flat, like you said Col. FC is slightly different from FB & EK have inserts in them. NOT on the Commercials or Standards though.

Rob J

[Blown_FC]

Thanks guys....the reason I asked, is I've foound a set of four for about $40 in good condition.   Rares sell them at over $100 each brand new, and I can't find any good FC plates at that price, so I may end up buying the EK plates instead.

Cheers

Mark

[TorqueFC]

Mark. i would strongly advise you not to buy them if you want to fit them to an fe fc. below is a picture (or two) of fc scuff plates, and fb ek ones , as you can see they are quite different. 1. the holes dont line up 2.i believe that even if you drilled more holes, they still wouldnt sit  right.





regards
Darcy  

ps: i hope this helps ;)

[Blown_FC]

THanks Darcy...big help !

Guess I'll just have to keep searching for FC ones or pay the asking price from Rares !

Thanks Again

Cheers

Mark

[COL58FE]

on ya torque,
                    i've been proved wrong
again,cool but i have learnt something
too.guess i should could would have
put somewhere in my post the word
(assume) ;D
                                           cheer's col.

[earlyholdenfan]

Say Mark, if they wont fit your car, any chance of a pm with contact details as they will fit my Ek! ;)
Matt