Column mounted high beam switch

[blacky]

 Has anyone managed to successfully fit a high/ low beam switch to a standard column ?
 I would like to get rid of the floor mounted dip switch but keep the original look.
 Also , I just got a 2 speed wiper motor from Ken , what switch is the best to use ? ? ?

[Glenn 'Stinky' Stankevicius]

I have a torana switch for my "Ken's Wiper Conversion Kit".

What sort of switch would you use on the column? The only thing I could think of would be the old "bolt-on" indicator switch. With a little modification it could be adapted. There's no reason it couldn't be done, the wiring may need to be extended though.

[blacky]

 I was going to try one off a datsun 1200 or something like that .
 I have an LC torana that is on its way to the tip , will rob the switch out of it before it gets squashed.

[fastjbav6]

Use an FC headlight switch for the wipers via a relay so the instrument panel knobs look the same.
Regards Seb

[Glenn 'Stinky' Stankevicius]

The headlight switch for wipers has actually been done to my wagon. The torana switch works just as well and is probably less hassle to set-up. Just don't try to get rid of the little vacuum squirter mechanism, been there done that  ::). You will need to cut a little of the hex shaped stalk to get the knob (with grub screw) to sit flat on the dash though, measure twice, cut once.