News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

Rebuilding HR Front End (Part 3)

Started by Glenn 'Stinky' Stankevicius, November 06, 2004, 07:56:31 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Glenn 'Stinky' Stankevicius

November 06, 2004, 07:56:31 AM Last Edit: November 06, 2004, 07:57:57 AM by stinky
Does anyone have the dimensions for the spacer tool 3A11 that is used to install the lower control arms on an HR front end and the 3A12 for the upper control arms?
Or is there another trick I can use?

mcl1959

#1
November 07, 2004, 08:33:53 AM
The tool is only needed when fitting NOS lower arms because they have no thread in them.  Set the arm up in place on the bolt and then make a spacer which just fits in the gap between the arm and the crossmember.

Ken

Glenn 'Stinky' Stankevicius

#2
November 07, 2004, 11:11:10 AM
Cheers and thanks Ken, didn't get to it today anyway, on account of babysitting the tribe.
Print
Go Up Pages1
User actions