under floor crossmember

[mcl1959]

I need the piece of crossmember under the front floor between the inner subframe legs.
Its the piece that you would normally cut out if you were putting a 4 speed in an FC
You know the piece that the handbrake bracket bolts onto.
Anyone wrecking a car with this piece in rust free order.

All I need is basically between the 2 inner subframe legs
Any help or leeds would be appreciated.
I am in Vic but I wouldn't expect the postage to be more than about $20 from other states.
Regards   Ken

[davids_ute]

ken i have sent 2 emails(hope u got them) think i have got wat u want and i am in geelong not to far away u can call me on 03 52784474        regards david

[mcl1959]

Still looking for this piece of floor, surely there must be someone out there who has a wreck with a half decent bit of floor in it ?

It wouldn't cost much to post from interstate I believe - can anyone help?

Ken

[Glenn 'Stinky' Stankevicius]

Do you have a picture of the area that you need?

[mcl1959]

No I dont have a digital camera unfortunately

Ken

[Trevor_B]

Hi Ken,
You might try Centre Road Wreckers  - 1602 Centre Rd Springvale 3171  (03) 9547 7377

When I was there a couple of months ago they had a reasonable FC shell, although I didn't get under it to check for rust. Perhaps you could give them a call.

Alternatively you could try this guy in Castlemaine:

Bought some parts on Saturday from an old bloke in Castlemaine who had an FC Wagon and a Panel Van he is wrecking. Most good bits already gone (isn't that always the case?) although I got some good parts, like a HR disc brake front end ex the FC Wagon (needs some TLC & new rotor/calipers), headlight trim, couple of original washer jets and a grill (complete with a badge).  
This guys still does have some useable bits like front sub chassis, complete rear axle assy, steering box, Front right guard, rear tailgate & window for both (seemed in reasonable condition given that it was raining at the time of viewing). Also had other parts lying around along with a couple of EH's. Price was good for the bits I bought.
His name is Ron - Ph No 5472 3839
 

Trevor_B

[earlyholdenfan]

Ken, if you still have no luck, I would be msot willing to bring the diigi camera over and capture the offending part on film for you to post!
Matt

[slim]

Ken , I have just picked up an FE sedan , Im wrecking. If you can let me know if you have located what you need, And perhaps put a small diagram of area needed , I can Help . Cheers SLIM

[mcl1959]

Slim, thanks for that - I have a promise of one coming in 2 weeks but I will let you know if it falls through

Ken