News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

Rear main bearing seal for Grey motor

Started by Fraze, November 27, 2015, 08:56:58 AM

Previous topic - Next topic
Print
Go Down Pages 1 2
User actions

Fraze

#20
September 06, 2022, 07:12:36 AM
Prior to fitting the rope seal , use a centre punch and put 5 or 6 punch marks in the bottom of the groove in the seal channel in the block and bearing cap. Secondly use a good oil resistant sealant on the rope seal before fitting. These are tips I picked up from  research on seal fitting from the experts, also check out utube. Cheers,Fraze
Print
Go Up Pages 1 2
User actions