Smiths clock bracket

[ridgey_didge]

Can anyone help me with specifications for a bracket for a Smiths Clock (that goes on the rear view mirror stalk).  If someone has a bracket for sale that would be ideal.  Ken McL did post a few years back that he had a drawing for the bracket, but I have checked with him and alas, he has it no more.

If someone has a clock with bracket, could you do the measurements for me and maybe send me some close up photos?  My email address appears on my profile.

Cheers
David

[FCV08]

David

If you get some drawings or photos can you email them to me as well?

Cheers

Craig D

[mcl1959]

With thanks to Zulu, I have retrieved my original drawing which is reproduced here with mock up sketch.

if you want a copy sent to you then give me a pm

Ken





Sent from my iPad using Tapatalk

[FCRB26]

I can cut them on the waterjet
supply as a flat pack probably only take 30sec to cut ?

[mcl1959]

I'll send you the drawing, send me a pm with your address. The drawing is on paper, not electronic.

Ken

[FCRB26]

Should be enough detail there ill draw it tommorow on cad see how I go.

What material and thickness ?

pete

[mcl1959]

1mm mild steel

Ken

[mcl1959]

Distance between holes C is the distance between the holes on the mirror (I didn't have one here to check). The distance B to the side wall is half that distance minus 2 mm

Ken

[mcl1959]

I need the distance between hole centres on an FC mirror bracket from someone who has one handy please.

Thanks Ken

[fcwrangler]

Ken, 1-3/8" or 35mmtaken from the mirror base and the holes in the support.
Regards Jim

[FCV08]

Jim

Beat me by 30 seconds.

I got 36mm but leave it at 35mm due to parallax error

Regards

Craig

[Stewy]

Picture of what it looks like.





Cheers Stewy   8)

[FCRB26]

I cannot see the drawing properly to replicate it so if someone faxes it to me i will get a few cut should be around $6 each in 1mm zinc.

Pete

[ridgey_didge]

Pete - send me your fax number by PM and I will send you the diagram once my hard copy arrives from Ken.  I am happy to be your first customer at the (no room for bargaining) price of $6.

Cheers
David

[FCRB26]

0265746311 its a open fax number for the business.

Pete

[FCV08]

I'll be in for one as well Pete

[DJ]

Had a go at tweaking the shot Ken posted but no better for reading a couple of the dimensions, sorry. A fax may not transmit any better even on a fine setting. Enlarging may work though & sending several pages to put together.
It's a good diagram, maybe just a couple of closer shots of the measurements would do the trick.

[FCRB26]

I think kens onto it anyway.

[mcl1959]

original has been posted

ken

[FCRB26]

thanks ken.