FE shell

[FC Dave]

Stripped down a VERY rusty FE sedan today. Still on this shell is a good roof & b pillars with no seat belt holes. The rear quarters around the tail lights are ok too, until you get to the lower sections. Located Robertson NSW.  Just checking if any one wants bits like this. The rest is ready for a trip to China to make some Great Wall utes. Dave

[mcl1959]

Dave, can you post the details of the ID plate and chassis number please.
Would appreciate it.

Thanks. Ken

[FC Dave]

Hey Ken ID is 225 13798 S
Trim 355/465 AO
Paint 253/7773

Should be an FE special, Sydney Build.
Single tone Ascot Grey
Fall Red & Parchment Ivory interior.

I couldn't find the number on the inner guard. Are the FE ones in the same place as the FC?

This Id plate is available if anyone is interested.

[mcl1959]

the chassis number could be on the skirt near the battery if it is not on the drivers side.

thanks

ken

[FC Dave]

Ken, I have had a scratch everywhere, and no number on the sub.

Still available off this FE are some stainless trim, roof, rear seat, windscreen,ID plate, glove box lid & dash that was Chrome,Door strikers, cowl vent.. I have a couple of very rough sub frames if some one is looking for a K leg.

[hawk]

Hi Dave, do you have the boot springs available on the shell.
Regards,Greg.

[FC Dave]

No I don't, sorry.

[FireKraka]

Greg
I picked up a box of parts a while ago and have a number of boot springs PM me if you are interested I am in WA but it would not be hard to send something as small as them.

Regards
Neil H