Engineer

[Gordon]

Hi looking for a good engineer in the sydney area for V8 in FC anyone ?
Gordon

[Crumpsnr]

You could try
Brian Brady
42673969
0407939216

Last time I talked to him he was based at Thirroul but travelled to Shellharbour to look at my car and give advice and didn't charge because he already had another job down this way and it was on his way. Not sure whether he does work in Sydney but it'd only be a phone call to find out. I found he's very good to talk to, and gave me lots of helpful advice. Martyn

[Gordon]

Ok thanks for that i will give him a ring
Gordon

[Crumpsnr]

No worries  :) It's been a while since i spoke to him so I hope he works out for you. Regards, Martyn

[FC427]

Robert Elliott is the guy you want real nice guy and easy to deal send me a PM if you want his number .......FC427.......

[NES304]

What are they charging???

[FC427]

What are they charging???

NES FC sedan with v6 conversion,  shortened commodore rear end , rack and pinion, collapsible column ,fuel tank swap, seat mounts ,seat belt anchors etc etc   he required $400 for the first visit $1200 all up ......FC427......

[brett_f]

Last one i used that hadnt seen the vehicle before charged me $1500. That didnt include the slight mods he wanted. About the going rate in Vic.
Brett

[NES304]

What about NSW pricing?

[fink]

What about NSW pricing?

So what are you say'n,you did all that work on your car without one!norty boy  ???

[FC427]

What about NSW pricing?

NES $1200 and he is in Sydney ......FC427......

[brett_f]

Gaz i think you are talking to me. No i had an engineer involved from the start. Just didnt use him in the end as he turned out to be a d**kh**d.
Brett

[NES304]

So what are you say'n,you did all that work on your car without one!norty boy  ???

I have been dealing with an Engineer from the very start - hence my steering rack mounts are 8mm thick as per my thread (engineer request).

However, they are wanting to charge me nearly 3grand for the final tick of approval (but are not charging anything for information and checks in the lead up).

Which one is the one from Sydney?

[FC427]

I have been dealing with an Engineer from the very start - hence my steering rack mounts are 8mm thick as per my thread (engineer request).

However, they are wanting to charge me nearly 3grand for the final tick of approval (but are not charging anything for information and checks in the lead up).

Which one is the one from Sydney?

Insert Quote
Robert Elliott is the guy you want real nice guy and easy to deal send me a PM if you want his number .......FC427.......

[GMB-58FC]

Rather than start a new thread I hope one of the Tassie blokes spots this and can let me know of a good engineer to use here in Hobart???

[fe350chev]

I need one who doesnt mind a can and a yarn in western vic or SE SA