window regulator for drivers door

[surferboy]

Looking for replacement window winding regulator to fit drivers door

I've worn out another one  ::)
The teeth are razor sharp pointy things and keep slipping and jamming so you can't move the window. >:( I've resorted to driving my wagon around with the door panel off so I can juggle bits around to move the window !

Is it possible to modify the regulators from any of the other doors  ???
If it is.. could somebody post instructions (with pictures would be good ) as I would have to get someone else to do the modification for me (unless you can do it with one bent screwdriver and a hammer with a loose head...  I'm not much of a DIY type )

I have replaced the drivers door unit 3 times now. But using 2nd hand ones, they really don't last very long on my daily driver.

Does anybody produce a replacement one
Or can a new one from a different model car be used ?

Ta
surferboy
8) 8) 8) 

[FCRB26]

New runners and felt strips put major strain on the old winders.
I would not think there is a stronger unit than an old holden unit.
Some have done electric conversions but I think they too will start breaking teeth ect.

Why not pull one apart From a rear door and either make the arm longer or try get the gears from a rear as most have had a lot less use.
Also your channel alignments are a major contributing part I read the manual to help me work on getting it to slide up the channel smooth without a winder installed.
I used a piece of 3mm plastic and a hammer tapping the plastic into the channel to make sure the Bailey channels were set in properly.
I also used lynx deodorant with 'graphite' I know it sounds silly but as mentioned elsewhere this stuffs great for locks ect as well it goes on dry and lubricates.

Good luck
Pete