headlight problem

[robbzfc58]

iv'e just got an fb on the road. tonight the lights went out.switched them off for a moment ,then back on &they seemed ok.then lost them again.they seemed to go out when the revs climbed.it has generator &original headlights.  i thought i would start with the regulator,or should i go to the switch first.i do expect a few teething probs,the ute was last regoed in 1970
any suggestions gladly accepted
                              trev

[Jockster]

Trev
Check the wires where they go into the dipswitch on the floor, they often get damaged and rusty and don't connect properly, causing intermittent loss of lights, I have had this problem on an FC, FB, HR and HT over the years and in every case it was the dipswitch which was at fault
Cheers
Jock

[robbzfc58]

thanks jock.wouldn't have thought of that till i'd done every thing else.i'llcheck it first thing tomorrow & let you know.

[ACE]

Trev,
There is also a thermal circuit breaker (a set of points) on the back of the headlight switch. Sometimes these  just need a clean to solve the problem. I'd also clean and adjust the points in the regulator box. This is explained in detail in the Holden FE/FC workshop manual P/N m32590 Sections 12B and12E or bring it over and i'll check it out. ;D ;D ;D
Regards ACE 8)

[robbzfc58]

just picked up the ute from pb after 2 weeks...still not finished.  i had a quick look at the lights...the problem seems to be the contacts on the switch.
thanks for your help jock ;D & ace ;D
                           cheers trev