Window winder and Handle removal

[AndyJ]

Hi everyone,

I need to remove my Door lining, and while ago I saw a "tool" for removing the clips on the inside of the Winder and Door handles on Ebay. But is there any other tricks to getting these guys off? I don't want to mess up my lining by doing it wrong.

thanks

Andy

[fcdunedin]

I first saw this done @ a car wreckers and did the same myself
Get a rag and with the thickness of one piece slide it in between the handle and the door card and move it around 1 full cycle the rag will grab hold of the retaining clip and and move it enough to safely remove the handle.

[KFH]

You can get a suitable tool at Supercheap for around $9.00 a couple of years ago.  No damage to the trim when I used it.

Keith

[Glenn 'Stinky' Stankevicius]

Buy the tool if you can, get the one with the end folded at a right angle.
Sometimes the clips go on the wrong way when replaced so you might need two gos to get them off.
When the handles are removed use the bent end of the tool to remove the trim, slide it under the door trim then up to the retainer clip and pop them out. It should save your trims if you need to use them again later.

[FE 4 ME]

I got my handle remover tool from Repco, i was fortunate to get it when they had 20% off the store, but it's approx $10.00  its good quality..

see how you go

i should of had one when i got my 1st car, the screw driver wasnt really precious to the door trim or surrounds

my FE deserves some respect, ....." Respect your elders " ;D

"Have a Great Holden ( FE ) Day !!!"  :D :D :D

FE 4 ME

[surferboy]

Hi Andy

They are easy to use... even I managed to get my handles and door panels off  :o

( OK guys you can pick yourselves up off the floor now )

a few dollars at Rare Spares from memory


8) 8) 8)