Messages

G'day all,

I after photos of the routing of the steel brake line in the engine bay. The one that goes from the 4 way connector to the Lh flexible line.

cheers

Walks.

G'day,

I'm chasing  the 4 anti-rattle washers that go on the gearbox end of the gear shift lever and control rods.

Cheers

Walks

Ken,

       Have sent PM.

Cheers

Walks

I bought the vehicle dissembled and only have the 3 way for the rear axle. I'm going off parts book which lists it as a 4 way p/n 7411137. The connections are as follows:
master cylinder,
Front left cylinder,
front right cylinder and
rear brakes.

Cheers

Walks

Hi,

     Does any have a 4 way connecter for the front brakes for an FC for sale?

Cheers

Walks

Sold. PM me payment details. and I l'll send address.

Cheers Walks.

I am after the attaching screws for the accelerator mounting brackets aswell as the end spring and return spring.

Cheers Walks

G'day all,
             
              Does anyone in the Brisbane or surrounding areas have a Stromberg Carburetor for a 138 grey for sale?

Cheers

Walks

G'day all,

Can anyone recommend a gearbox shop in Brisbane to overhaul my three speed box.

Cheers

Walks

Thanks,

             Just measured the ones that were fitted and they are all the shorter bolts.

Cheers

Walks

Hi all,

   Just need the length of the bolts if anyone can help.

Cheers

Walks

Thanks Ken I'll PM with my details.

Cheers

Walks 

G'Day all,

                I'm after the mounting stud that screws into the block to allow fittment of the generator.

Cheers

Walks

Hi all,

          After removing the cylinder head of my engine (FX block with FB/EK head) I have found them all to be the same length. The parts manual list there being. 8 short and 7 long bolts. Can anyone tell what sizes they should be as I'm replacing the bolts.

Ken,

        There is no prefix to the engine number. I can only assume that at some point it has been bored to take the larger pistons.

Cheers

Walks

Ken,

        The number that is next to the part number is D 121. Also as I had to remove the cylinder head I was able to confirm that the engine is a 138 as it has p/n 7406476 pistons fitted. The engine block s/n is 116656 & p/n 7400479.

Cheers

Walks

Ken,

        I'll have a look tonight and let you know.

Cheers

Walks

Thanks Ken,

                     Mine has a hole at the front and a hole at the the back with a plug fitted.

Cheers

Walks

Hi all,

          Can anyone tell me if the cyl head I have on my engine is the correct one, as when I bought the car it came with the engine in pieces and was told it was a 138 bought as a replacement when the original engine block cracked. The engine (minus the head and flywheel) I have since discovered is from an FX. The part number cast on the head is 7412811.

Thank you

Walks

Does anyone have a bosch starter motor for sale in the Brisbane area.


Cheers

Walks