Messages

Hi Phil

Sent you a pm.

Many thanks

Dave W

Sorry guys and gals

I have a FE sedan and there is a metal ring in the back of the steering wheel to stop it cracking.

Cheers

Dave W

Hi all,
I am after a steering wheel metal ring that fits in the back of the steering wheel.

Cheers

Dave W

Thanks for your help guys.

I was using mig wire but hoped to get the proper circlip .

Cheers

Dave W

sorry

Forgot to say i have fe's

Dave W

Hi All

I'm after a couple of circlips that hold the brake cable ball in place for my two holdens.

any help will be appreciated.

Dave W

Hi all

I'm having to replace my wishbone pivot pins  went onto Rare Spares web site and couldn't find the lower inner pins.
I rang them today and found they haven't sold them since 1992.

Any body know where i can purchase the pins any where else.

Cheers

Dave W

Hi Ken

Thanks for that, i didn't think they would come out the factory with a offset.

Cheers

Dave W

Hi all

I noticed on my 57' FE ute that the rear passenger wheel was nearer to the arch than the rear driver side (offset about 3/4') i have been told by a friend that this was how they came out the factory
I have looked at the springs and axle and don't see anything wrong is my friend right.

Any assistance on this would be grateful.

Cheers

Dave W

Thanks Jim.

Cheers

Dave w

 Hi to you all,

Just wanted to know if the rear springs on fe ute are the same as on the fe special sedan?

Cheers

Dave W

Many thanks all

I will email daley's monday, again many thanks

Cheers
Dave W

Hi to you all'

Anybody know where i can get red wind lacing From? need 6 metres.

Cheers
Dave W

Thanks Graeme
I didn't see that one on google but i think it may be the one i'm after because on ebay is down as Belgrave South.

Many thanks
Dave W

Hi all
I bought a rear seat panel from reproduction motor trimmers on ebay and with the size i need to pick up as they don't post i sent three messages to ask where they are based? no answer yet but i'm going to Melbourne On monday as i am from Bendigo can't see an answer before sometime monday!

can anybody help where they are based.

cheers

Dave W

Hi to everyone
I'm after FE Holden rear spring spacers can any body help where i might purchase these, i know you can get one's from rare spares but i would prefer originals if possible.

Cheers

Dave W

hi all
thanks everybody for the help and those at the fe fc auction last nite got running just right!

many thanks
Dwortho

Thanks Ted

Cheers
Dwortho

many thanks hsv-001

Dwortho

Thanks hsv
yes realized i was 180 degrees out, don't know if i was right but turned the motor till number 1 intake was coming up then kept turning till the ball marker  was at the timing point.it's running rough so i'll try your method'

cheers

Dwortho