Print Page - Parts catalogue referencing

Title: Parts catalogue referencing
Post by: Not Happy Jan on November 27, 2016, 08:03:34 AM

Hi All
How do you find out what size the bolts are that secure the generator. I can't find any reference to them in the master parts catalogue.
Don't know if I'm looking in the wrong place or they're not there!

(https://s22.postimg.org/l0hx1ndfx/image.jpg) (https://postimg.org/image/l0hx1ndfx/)

Thanks,
Nick

Title: Re: Parts catalogue referencing
Post by: Dr_Terry on November 27, 2016, 08:23:19 AM

I'm not sure if it's listed in your edition, but mine lists all the generator mounting bolts, nuts & washers (including their size) in section 2.275.

Dr Terry

Title: Re: Parts catalogue referencing
Post by: FCRB26 on November 27, 2016, 08:24:31 AM

Pretty sure 5/16 UNF do you need the hex stub on the front of the engine ? i would have a full set up here.

(found them subframe bolts too they were second hand in the packet)

Title: Re: Parts catalogue referencing
Post by: Not Happy Jan on November 27, 2016, 11:26:30 AM

Thanks Dr Terry. Found it,
Got the Hex stub. Thanks Pete.
If you send me the sub frame bolts then stick those on too please that would be good.

I have just found an old generator with the bolts on and they are half inch???

(https://s12.postimg.org/vk68wwx4p/image.jpg) (https://postimg.org/image/vk68wwx4p/)

Title: Re: Parts catalogue referencing
Post by: mcl1959 on November 27, 2016, 04:17:16 PM

Yes, 1/2 inch head size, 5/16 unf thread

Ken

FE-FC Holden Discussion Forum

General => General Board => Topic started by: Not Happy Jan on November 27, 2016, 08:03:34 AM