DEMISTER VENTS

[Ed]

I am tooling up the vents again.

Thanks for those emails which have prompted me to get back into it.

Cheers

Ed

$45/pair for FE FC Holden club members
$50/pair for non club members.
+$5 postage and handling.
(one more reason to join a club if you're not already in one)

[slim]

When there ready I will take 2 sets ED. Cheers SLIM

[tmudie]

2 sets for me thanks Ed

Tony

[mike]

Hi ED I would also like two sets,

regards mike.

[Flamed_FE]

Ed

I'm very interested, but don't don't know anything about you prior run(s).  Can you point in the correct direct or supply some details? (based of the orginals? fit OK/Good/perfect? etc)

Al

[Ed]

Hi Al,

The repros are directly molded from the orginal metal duct.

They will fit up exactly as originals provided an insulating piece of foam is used on the lower face (I can supply this - originals used a fibre pad).

Feedback received suggest mounting methods such as velcro tape or using metal speaker clips on the duct with success.  I like both ideas.

please find following some quick pics of the vents.












Cheers

Ed

[Flamed_FE]

Cool!  I'll take a pair.  Shoot me an IM or email about when / how you want your spondulies

Al

[folie]

Hi ED I would also like two sets,
 
regards Bryan.

[robbzfc58]

can someone confirm that these will or wont fit an fb
                           cheers trev

[Jonno]

I would also like a pair,

thanks, jon :)

[Harko..]

Better build me a set too ED .
And Im not sure if they will fit FB Trev but would be interested to know also , Cheers      Harko

[FE_UTE]

Harko and Trev
The vents on the fb are 40mm wider and get attached at the back of the vent.
The fc ones could be adapted to fit.
Have loaded a couple of photos showing both under the heading "My Cars"
http://photo.starblvd.net/feute
Hope this helps
Gary

[HARKO]

Thanks Gary moocho  apprecionardo mate.
ED Ill take enought to do the Ute and the Van please , Was never any good at maths

[robbzfc58]

thanks gary       2 pairs for me too please ed
      care ful you don't double my order coz i sent you a pm a few days ago!
             thanks trev ;D

[Spinner]

I'd like to get 3 set smyself.  Non-club member at teh moment.

Let me know on spinner@mpx.com.au how to pay etc.

Cheers

[colt]

ED,
I'd like 1 x pair please ED, 0401779510. Thanks.
Spinner, will a 60 class Garrett engine fit under the bonnet of an FE?

[Spinner]

Yair, one would with a bit of work.  I think that the firewall needs to be recessed a tad.  Even so, if you use bored out versions like those in the picture, the car won't have the grunt of a bored Canadian Block FE.

 :D


Spinner

[Sarge]

Is it to late to put my hand up for a set. If it's OK then let me know when and where you want your money sent.

Regards Sarge
0421165351
ddaam@bigpond.com

[Tony FC5859]

Hi Ed, I'd like to get a pair of demister vents from you, are the still available?, thanks Tony

[Martin]

Me, too, Ed - if they're still available.

Please send me a pm or email me at
lewistraining@ozemail.com.au

Many thanks.

Martin