News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

Snap Sacs

Started by Glenn 'Stinky' Stankevicius, March 25, 2017, 10:48:53 AM

Previous topic - Next topic

Glenn 'Stinky' Stankevicius

Now that I have your attention  ;D
Snap Sacs are the plastic inserts that are pushed into the door trim clip holes, generally at the top of the door to stop water reaching the door trim clips or the door trim itself.

Could someone with an unmolested car let me know how many are used exactly on each door?

old-blu

 Hi Stinky.  Remove the door cards & count up the number of round holes. They go down each side & across the bottom of each door.  Simple!    Cheers old-blu.
6th, may 1958 "I was there".

old-blu

 Me again.  Of course they go across the top of each door as well. Count up the round holes. old-blu.
6th, may 1958 "I was there".

Glenn 'Stinky' Stankevicius

I thought they were only used on the upper holes?
One of the old wrecks that I had, which appeared untouched, only had the tops and maybe a couple down each side  ???

Harv

Quote from: stinky on March 25, 2017, 06:13:22 PM
I thought they were only used on the upper holes?
One of the old wrecks that I had, which appeared untouched, only had the tops and maybe a couple down each side  ???

My memory of the EK door cards are like this too. The door has more holes (and the trim more clips) than the number of Snap Sacs required. On the EK, some of the door holes are so small that the clip will go in, but the Snap Sac will not.

Cheers,
Harv

mcl1959

I believe you are correct Glenn, the parts book is not very helpful with this item and I don't have a car here.
However, I feel they go across the top and down the catch side of the door. I don't think they go down the hinge side or across the bottom.
My feeling is the holes are different diameters, if you try to push the "snap sac" plastic thingy into the smaller holes, it folds up inside or just won't go in properly. This makes the door trim clip very tight and hard to remove.

Ken

FE_UTE

My ute has 5 across the bottom and 2 on the door opening side only
ie. none across the top or hinge side

Cheers gary

FE_UTE


hsv-001

In that photo I notice the obvious difference in the hole sizes and it appears that there are a few missing . I may be wrong .

FE_UTE

There are two size holes...just try with the clips
there is just over a mm difference
The photo may be misleading..all the holes without the snap sacs are the same... smaller than the snap sac holes

I also checked with a rear sedan door ..they have snap sacs along the bottom, all the hinge side inc the top one and one on the opening side
half way around the curve

8 snap sacs and 5 clip holes in total