News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu

Ute rear floor under false plywood cover

Started by RichFC, October 03, 2012, 02:32:33 PM

Previous topic - Next topic

RichFC

Gday Guys,I was wondering if anyone could help me in regard to rust repairs in ute floor{rear}.
Is the wagon floor pan exactly the same as the ute? Also is the petrol tank in the same position on both ute and wagon.
And is there something that goes over the petrol tank in the utes or does the spare wheel sit directly on top of the tank?
Im assuming there would have been something like a cover plate otherwise the spare wheel may damage the petrol tanks sender unit or
foul on the wiring for it?
Any help would be appreciated!
My petrol is ok but where it is mounted is just about rotted out and tank is being held in only by a couple of screws and a fair bit of rust!
Thank you very much!

mcl1959

Wagon floor is the same as ute and petrol tank is the same as well.
The spare wheel does sit on top of the tank.

Ken

zulu


What Ken said, also there were bitumous cut outs a few mm thick in the pressings of the tank and a sheet of the same stuff on top of that, at least that was the case with the sedans, not sure about the other variants

My ute had nothing left on top of tank, there is only enough room in there for a standard wheel and tyre to just slide in and out the spare tyre door

Gary

RichFC

Thanks very much guys ! Much appreciated !

RichFC

Im guessing i should start looking for a full fc wagon floor pan ! There goes the budget !

thecanoeguy

did you have any luck with the ute floor , i just got a ute and my rear floor is cactus