FE-FC Holden Discussion Forum
September 29, 2024, 11:22:19 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > General Technical (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Rev Tacho Help Needed!!!
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Rev Tacho Help Needed!!!  (Read 1451 times)
TorqueFC
Guru
*****
Offline Offline

Posts: 1053


Modified?


View Profile
« on: November 13, 2005, 06:13:10 AM »
0
hi guys

bought a rev tacho for the ute, just dont know how to wire it up. what wire goes where?? any help is greatly appreciated!!!

regards
Darcy

here is a pic Wink
« Last Edit: November 13, 2005, 06:13:31 AM by torquefc » Logged
tests have proven that the final words before a fatal urban car crash are "OH ****"

in a rural car crash they are " Hold my stubby and watch this for skill!"
craiga
Guest
« Reply #1 on: November 13, 2005, 09:09:30 AM »
0
My guess is:
Black to vehicle ground
Red to dash lights +ve
Blue to points (coil -ve)
Logged
fc_1958
Junior Member
**
Offline Offline

Posts: 66


FC5959


View Profile
« Reply #2 on: November 15, 2005, 12:26:21 PM »
0
Hey Torque

My Guess

Red - Dash lights
Black - from brass nut to ground

The two wires coming out of the grommet  -
one to coil -ve
one to accessories fuse +ve

Personaly I would go for the grey being -ve,
however not sure Huh

Don't know if you will damage it if wired in reverse
But ....  at least the gauge will light up Grin
Logged
Andrew..... AKA   FB 60 on the "other" forum.
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.027 seconds with 19 queries.