FE-FC Holden Discussion Forum
November 26, 2024, 08:55:41 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > General Technical (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > How to Hang Flex Plate ???
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: How to Hang Flex Plate ???  (Read 1505 times)
Blown_FC
Senior Member
****
Offline Offline

Posts: 737


FC Holdens & Mini Coopers....Cars of the Century


View Profile
« on: June 21, 2005, 05:41:31 AM »
0
I've bought a new FLex plate to fit to my Red 202 so I can match up a Trimatic, but I'm not sure which way to hang it ?

The flex plate has recessed areas on one side for the converter to bolt up to ( 3 on the outside and 1 big recess in the middle ).

WHich way does the recessed side face....the motor, or the converter ?

ANy help greatly appreciated.

Cheers
Mark
Logged
cer444
Full Member
***
Offline Offline

Posts: 104


138 "Big Block" Grey


View Profile
« Reply #1 on: June 21, 2005, 08:06:58 AM »
0
Hi Blown FC

You will find the flex plate is not dead flat.

When you look at the engine side on, I think The  ring gear is more towards the engine and the crank flange section is towards the transmission.
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.026 seconds with 19 queries.