FE-FC Holden Discussion Forum
November 23, 2024, 04:19:21 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > General > General Board (Moderators: RET, Glenn 'Stinky' Stankevicius) > EK Heater
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: EK Heater  (Read 2204 times)
mike
Junior Member
**
Offline Offline

Posts: 91



View Profile
« on: April 17, 2000, 12:00:00 PM »
0
My EK Special is fitted with a standard heater.  1. Is this the type of heater people refer to a warmride heaters (box shaped with central fan knob)? 2. Where and can I get a replacement water valve for it as mine leaks?
Thanks, Mike
Logged
mike
Junior Member
**
Offline Offline

Posts: 91



View Profile
« Reply #1 on: April 17, 2000, 12:00:00 PM »
0
OK stupid me it is a warmaride (written on the front panel).  Second question though, what is the wire/tube (thin steel about 2mm) which runs from the water shut off valve to the back of the unit.  Also, I run a red motor and which are the best take off points to feed nice hot water into the heater ie off the carby sie of the thermostat housing (two points) or off the water pump (plug side) and the head?
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.033 seconds with 19 queries.