FE-FC Holden Discussion Forum
November 25, 2024, 07:20:15 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > General > General Board (Moderators: RET, Glenn 'Stinky' Stankevicius) > Rear wheel cylinders
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Rear wheel cylinders  (Read 1549 times)
andyK
Guest
« on: May 21, 2001, 12:00:00 PM »
0
Ive fitted a HR rear end to the FC.  Its from a drum brake front end HR and I read the cylinder size is different.  2questions.    1. are the rear shoe sizes different as well?                2. can I change the cylinder to the correct size one?
Logged
Tim
Guest
« Reply #1 on: May 22, 2001, 12:00:00 PM »
0
The difference in rear brake shoes are if they are off a comercial ie ute/panal van (they will be wider & don't have a notch for the pushrods out of the slave cly. Also later HRs had self adjusting rear brake mechanism.
Logged
Ken McLean
Guest
« Reply #2 on: May 26, 2001, 12:00:00 PM »
0
HR Rear brake lining area of the HR (62 sq mm)is greater than that of the FC(56 sq mm).  Also the rear FC brake cylinder is 1 and i/16 inch versus the HR with 13/16 inch diameter.  Unfortunately the FC wheel cylinder will not fit the HR rear end. The problem you will have is that too much pressure will be applied to the rear brakes causing rear brake lock up in an emergency stop.  This is very dangerous.  Suggest you fit a HR front end as well.   Regards  Ken
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.024 seconds with 17 queries.