FE-FC Holden Discussion Forum
November 17, 2024, 01:33:19 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > Restoration Help (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Tightening swivel ball joint on mirror ???
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Tightening swivel ball joint on mirror ???  (Read 2611 times)
Dave Lakin (Davo Lako)
Senior Member
****
Offline Offline

Model: FE
Posts: 540



View Profile
« on: January 21, 2013, 12:58:36 PM »
0
http://i1211.photobucket.com/albums/cc439/DavidLakin/photo33_zps6a653982.jpg

Any tips on how to tighten these Huh

Mine is as loose as a Nan's nasty ... The screw doesn't help ... Squrt in some silicone or glue Huh

Any ideas fellas Huh

Cheers , Dave .
Logged
When I was a young man I spent most of my money on cars , beer and women (in that order) ... the rest ... I just wasted !

Port Macquarie NSW
Rusty_T
nsw-club
Senior Member
****
Offline Offline

Posts: 680


I love YaBB 1G - SP1!


View Profile
« Reply #1 on: January 21, 2013, 04:08:10 PM »
0
Dave,

That little screw on the back of the mirror normally tightens them.

Rusty
Logged
mcl1959
vic-club
Guru
*****
Offline Offline

Posts: 6155


FE's rule


View Profile
« Reply #2 on: January 21, 2013, 05:54:43 PM »
0
When these are over tightened the dish on the back of the ball gets deformed and no longer holds the ball tightly, unfortunately the only way to fix properly is to remove the mirror and repair the dish and then replace the mirror

Ken
Logged
Stewy
sa-club
Senior Member
****
Offline Offline

Model: FE
Posts: 881


FErgus 1957 FE Special Station Sedan


Jeff Stewart
View Profile
« Reply #3 on: January 21, 2013, 06:25:58 PM »
0
If you can remove the screw you might be able to put in the hole something of a slightly smaller diameter as a spacer to put a bit of pressure on the dish, but only if the thread in the housing hasn't been stripped.
If it is I would probably go the clear silicon once the mirror is in the correct position.

Cheers Stewy   Cool
Logged
No matter how much you push the envelope, It'll still be stationery
Maco
nsw-club
Senior Member
****
Offline Offline

Model: FC
Posts: 963



View Profile
« Reply #4 on: January 21, 2013, 09:15:58 PM »
0
Dave,

TOO much tension on the screw!!

Cheers
John
Logged
Better in Green
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.038 seconds with 20 queries.