FE-FC Holden Discussion Forum
April 29, 2024, 03:12:36 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > General Technical (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Bosch heater fan removal
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Bosch heater fan removal  (Read 1810 times)
Not Happy Jan
nsw-club
Senior Member
****
Offline Offline

Model: FC
Posts: 947


Aussie adventure


View Profile
« on: June 04, 2012, 09:09:30 AM »
0
Hi All
I have a bosch heater that Im trying to put the core into my warmaride body.
How do you remove the fan motor from the bosch. I have taken off the three screws from the mounting bracket but there is a wheel at the back that does not let it come through. Can you remove the fan from the motor.Huh
Any thing else I need to know when doing this conversion.
Thanks. Nick
Logged
You can never have too many!
Port Macquarie NSW
mcl1959
vic-club
Guru
*****
Offline Offline

Posts: 6155


FE's rule


View Profile
« Reply #1 on: June 04, 2012, 05:20:13 PM »
0
There should be a grub screw on the fan hub which when loosened should allow the fan to be removed from the motor shaft

Ken
Logged
Not Happy Jan
nsw-club
Senior Member
****
Offline Offline

Model: FC
Posts: 947


Aussie adventure


View Profile
« Reply #2 on: June 04, 2012, 05:47:47 PM »
0
Thanks Ken.
I was just going to address it to you Cheesy Cheesy Cheesy
But I thought I would put it out there for everyone Grin
Next time I should wear my glasses.
Nick
Logged
You can never have too many!
Port Macquarie NSW
Not Happy Jan
nsw-club
Senior Member
****
Offline Offline

Model: FC
Posts: 947


Aussie adventure


View Profile
« Reply #3 on: June 05, 2012, 05:51:53 PM »
0
the grub screw was actually out. The blade had just rusted on to the shaft. managed to get it off by removing the rear wheel which had the grub screw in but was loose and just fell off???
Logged
You can never have too many!
Port Macquarie NSW
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.034 seconds with 20 queries.