Removing lower control arms HR front

[freddyc]

How do I remove the lower conrol arm shafts. The ones that go through the HR front end. Book says use tool #???, is there another way?
regards fred

[mcl1959]

I assume you want to replace the shaft??? The easiest way is to grind 2 flats onto the shaft and undo with a shifter. If you want to take out the shaft and use it again then you will need to make a tool from an old bush. It will need a cap welded onto it so that you can tighten up the bush onto the shaft and then unscrew the shaft.

Ken

[freddyc]

Thanks ken am replacing the shaft, is there anything else I should know ? about replacing
regards fred

[mcl1959]

Tighten it up as tight as you can

Ken