Chassis Kit

[wayne.c]

Would there be some one on the forum with pics and dimensions of a chassis kit that i could fabricate for my Ute also what other strengthening would be required in the front end (RB30 develops about 600bhp).
Thanks for any advice.
Wayne   

[fink fc]

WAYNE,I THINK THE BEST THING YOU COULD DO IS CONSULT A APPROVED ENGINEER.IN VIC MOST VICROADS  APPROVED ONES CONVERSE WITH MOST CAR CLUBS.
IF YOU JUMP ON THE''OZ RODDERS FORUM'' THEY SHOULD TELL YOUWHO'S OUT THERE IN YOUR STATE & WHO IS THE BEST FOR YOUR BUILD.

[fe350chev]

i was gunna do an rb30 turbo but it comes in too big for a legal conversion in victoria, let me know if u intend on getting it registered in vic or if its a strip car pls as i have had numerous say 2.9ltrs is the cutoff so stuffed my plans. id probably go for a toyota twin turbo j motor now if going that direction but in have been thinking lexus v8 as same weight rule applies. there is a conversion place in adelaide that does 350's and they strengthen more than a rod shop kit, they do tell me (engineers) that if u stick to bolt on stuff, it may be easier to pass. Im going though same planning so this will be interesting discussion to have. just outa interest, what box u gunna run? auto or manual, probably better auto if boosted. might have to get it passed in sa and then re register here for me to go larger.