FE-FC Holden Discussion Forum
November 26, 2024, 04:41:22 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > Modification Help (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > custom "bullet" Centre Caps
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: custom "bullet" Centre Caps  (Read 2843 times)
grey58fc
Junior Member
**
Offline Offline

Posts: 52


View Profile
« on: December 21, 2009, 12:41:51 PM »
0
does any one know what the outside diameter of the chrome bullet shaped centre cap would need to be for it to fit a HK premier? the only ones i can find are off the american ebay and are measured in inches, so a measurement in inches and centimeters would be appreciated.
Logged
waynos
Senior Member
****
Offline Offline

Model: FC
Posts: 787

patience grasshopper


View Profile
« Reply #1 on: December 21, 2009, 06:33:41 PM »
0
multiply that inch measurement by 25.4 to get a metric conversion
i roughly measured my ht rims,the centre was about 63 mm/2.480 inches
Logged
The grinder is mightier than the sword.
grey58fc
Junior Member
**
Offline Offline

Posts: 52


View Profile
« Reply #2 on: December 22, 2009, 09:53:01 AM »
0
thanks legend!
i got the same 63mm when i went out to check em then! my centre caps are on the way! Grin
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.031 seconds with 20 queries.