FE-FC Holden Discussion Forum
September 25, 2024, 09:15:30 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > Restoration Help (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Bonnet Latch Pin
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Bonnet Latch Pin  (Read 2363 times)
KFH
qld-club
Senior Member
****
Offline Offline

Model: FC
Posts: 683



View Profile
« on: December 20, 2009, 07:03:19 PM »
0
I am contemplating removing the hold down latch attached to the bonnet so I can  have it re plated.  This is attached with a pin that is penned over at one end.  Is there a replacement pin available or should I use a bolt.  Any thoughts appreciated.

Keith
Logged
I was born with nothing and still have most of it left
FC427
nsw-club
Guru
*****
Offline Offline

Model: FC
Posts: 2457


I love YaBB 1G - SP1!


View Profile
« Reply #1 on: December 20, 2009, 08:26:15 PM »
0
Keith when you remove the pin  you can reused it... it can be center bored and tapped and a small button head bolt screwed in to retain it or make up a new pin  if you are chasing originality ...But a bolt Yuk  Shocked Shocked ........FC427.....
Logged
As I lay rubber down the street I pray for traction I can keep, but if I spin and begin to slide please dear god protect my ride
KFH
qld-club
Senior Member
****
Offline Offline

Model: FC
Posts: 683



View Profile
« Reply #2 on: December 20, 2009, 10:40:43 PM »
0
Thanks Mark.  I agree with you about the bolt.  Thanks for the suggestion - easy enough to do.

Keith
Logged
I was born with nothing and still have most of it left
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.031 seconds with 19 queries.