FE-FC Holden Discussion Forum
November 27, 2024, 09:23:54 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > General Technical (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > ryco r4p filter assembly
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: ryco r4p filter assembly  (Read 2316 times)
stapla
Full Member
***
Offline Offline

Model: FE
Posts: 197

I love YaBB 1G - SP1!


View Profile
« on: November 29, 2009, 07:22:32 PM »
0
Hi All,

Whats the correct method for assembly of a ryco external engine oil filter  ?

Does the spring assembly go the below filter element ?

Maybe from bottom to top - spring, washer, claw bit then filter on top ?

Does the oil restrictor go on the outlet ?

Top side hole to near dissy, bottom center hole to near fuel pump ?

Cheers
Peter.
Logged
mcl1959
vic-club
Guru
*****
Offline Offline

Posts: 6155


FE's rule


View Profile
« Reply #1 on: November 29, 2009, 09:25:04 PM »
0
Peter, spring goes at the top to push the filter down.
Restrictor is on the outlet which has a short hose and goes to the hole below the filter. The inlet comes from a tee where the oil light switch is.

Ken
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.031 seconds with 19 queries.