FE-FC Holden Discussion Forum
November 24, 2024, 07:21:19 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > General Technical (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > Door Rubbers
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Door Rubbers  (Read 2044 times)
Ken's 57
nsw-club
Senior Member
****
Offline Offline

Model: FE
Posts: 292



View Profile
« on: September 15, 2008, 02:18:30 PM »
0
Both of my original front outer door rubbers are in reasonable condition except for the section that runs along the sill panel under the scuff plate. I ordered rubber to suit and pictured below is the new section. If facing forwards on the driver's side, have I got it the right way up or should the wider profile be at the top? The originals were really damaged and it wasn't obvious when removing them.

Cheers........Ken



Logged
Bob_FC_Ute
Newbie
*
Offline Offline

Model: FC
Posts: 22

I love YaBB 1G - SP1!


View Profile
« Reply #1 on: September 15, 2008, 02:27:20 PM »
0
The orientation that you have shown in the photo is correct for fitment.
regards Bob
Logged
Ken's 57
nsw-club
Senior Member
****
Offline Offline

Model: FE
Posts: 292



View Profile
« Reply #2 on: September 15, 2008, 09:41:48 PM »
0
Thanks Bob.
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.029 seconds with 19 queries.