Front End

[KFH]

What is the easiest way of getting new bump stop rubbers back into the control arms?  Unsuccessful so far.

Keith

[mcl1959]

Little bit of rubber grease works wonders

Ken

[FC427]

Keith put some slippery on them half wedge them in and give  them a hit with the rubber mallet ......FC427....

[KFH]

Thanks Ken and FC 427 for the hints. After a few trys  I found it was easy to fit them by putting the control arm against one jaw of the vice and the bump stop against the other jaw  squeeze them in.  I used rubber grease for the first two but I found it unnecessary for the others.  On the jaw that had the control arm resting against it I used a small piece of timber and some rag to protect the new paint on the control arms.  Very quick doing it this way.

Keith