FE-FC Holden Discussion Forum
November 26, 2024, 09:29:08 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > General Technical (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > transmission seals
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: transmission seals  (Read 1564 times)
JohnBM
wa-club
Full Member
***
Offline Offline

Model: FE
Posts: 197


View Profile
« on: January 08, 2012, 01:50:02 PM »
0
Looking for selector shaft seal for grey motor '57 FE. I believe GMH part numbers are 7400255 and 7403035. Oil is leaking from under dust cover at a rapid pace. GMH workshop manual does give instructions on how to remove the seal, but I've tried all avenues over here to obtain one without any success. Any help would be appreciated as to where I can obtain one.
Logged
mcl1959
vic-club
Guru
*****
Offline Offline

Posts: 6155


FE's rule


View Profile
« Reply #1 on: January 08, 2012, 02:08:22 PM »
+1
The original seal is a bevel shaped cork component. Not available to my knowledge. I have had success using an O ring in place of the cork seal. If you remove the cast iron housing that holds the seal you can take this to O ring suppliers to find the best fitting solution.


Ken
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.036 seconds with 20 queries.