jack_fc
Senior Member
 Offline
Model: FC
Posts: 745
SouthWest Coast, Victoria
|
 |
« on: February 01, 2011, 01:01:41 PM » |
0
|
Gday All
I need some advice on how to remove and refit the paint seperators (between taillights and bumper) on an FC sedan.
How are they attached?
Dont want to damage them while removing...
thanks
jack
|
|
|
|
|
Logged
|
"when I was a young lout, it was all about sex, drugs, rock'n'roll, beer and hot Holdens. Now I'm an old lout, but I've still got the old Holdens and beer..."
|
|
|
customFC
nsw-club
Guru
Offline
Model: FC
Posts: 5900
Ask me about microwaving cats for fun or profit.
|
|
« Reply #1 on: February 01, 2011, 02:13:30 PM » |
0
|
These chrome pieces have tabs that insert into slots, they then fold over the panel joint to hold them in place.
Take a look in the boot below the taillights and you will see the tabs folded over.
Be careful straightening then, as they sometimes break when folded too many times.
Regards
Alex
|
|
|
|
|
Logged
|
|
|
|
jack_fc
Senior Member
Offline
Model: FC
Posts: 745
SouthWest Coast, Victoria
|
|
« Reply #2 on: February 01, 2011, 03:22:35 PM » |
0
|
Thanks, Alex  My car is at the painters; he rang asking if I knew how to remove them - bit hard to investigate when the car is nowhere near me! I'll ring him and pass on your much-appreciated advice. Regards jack |
|
|
|
|
Logged
|
"when I was a young lout, it was all about sex, drugs, rock'n'roll, beer and hot Holdens. Now I'm an old lout, but I've still got the old Holdens and beer..."
|
|
|
|
mcl1959
|
|
« Reply #3 on: February 01, 2011, 07:24:17 PM » |
0
|
After straightening, gently tap from the rear. If you prise them from the front, they will possibly break off.
Ken
|
|
|
|
|
Logged
|
|
|
|
jack_fc
Senior Member
Offline
Model: FC
Posts: 745
SouthWest Coast, Victoria
|
|
« Reply #4 on: February 01, 2011, 08:21:27 PM » |
0
|
Ken, Thanks for that very good advice cheers, jack |
|
|
|
|
Logged
|
"when I was a young lout, it was all about sex, drugs, rock'n'roll, beer and hot Holdens. Now I'm an old lout, but I've still got the old Holdens and beer..."
|
|
|
|
GMHwagoon
|
|
« Reply #5 on: February 02, 2011, 05:09:50 PM » |
0
|
when you do straighten the tabs lightly tap them half way out then tap them back in
do this a couple of times and it will loosen them up better
|
|
|
|
|
Logged
|
|
|
|
jack_fc
Senior Member
Offline
Model: FC
Posts: 745
SouthWest Coast, Victoria
|
|
« Reply #6 on: February 02, 2011, 06:13:41 PM » |
0
|
Thanks, Greg That's the very best thing about this forum - so much great practical advice, all for the asking! cheers, jack |
|
|
|
|
Logged
|
"when I was a young lout, it was all about sex, drugs, rock'n'roll, beer and hot Holdens. Now I'm an old lout, but I've still got the old Holdens and beer..."
|
|
|
|
