FE-FC Holden Discussion Forum
November 23, 2024, 10:56:18 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > Technical Board > Restoration Help (Moderators: RET, Glenn 'Stinky' Stankevicius, gp) > King Pin Installation
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: King Pin Installation  (Read 1848 times)
plumer46
nsw-club
Junior Member
**
Offline Offline

Posts: 48


FE Ute


View Profile
« on: November 01, 2008, 02:27:38 PM »
0
Hi

I am installing the front suspension on my FE Ute, I am not sure which way the King Pins and bolts go, does the bottom nut on the king pin and grease nipples face to front or rear.

I am not sure what is Left and Right re the King Pin assemblies, could someone assist me and possibly a picture of an assemblied front end, the manual does not clearly state the difference.

Regards

John G Huh
Logged
mcl1959
vic-club
Guru
*****
Offline Offline

Posts: 6155


FE's rule


View Profile
« Reply #1 on: November 01, 2008, 05:24:02 PM »
0
John - page 54 of the manual shows the correct way to install all parts. The king pin is installed with its grease nipples to the front. The lower bolt is inserted from the front with the nut going on the back. The upper bolt is inserted from the back with the nut on the front.

Hope this helps

Ken
Logged
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.035 seconds with 20 queries.