FE-FC Holden Discussion Forum
November 24, 2024, 11:55:14 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: The FE-FC Holden Car Club of NSW are proud to host the 19th FE-FC Holden Nationals. Check out the announcement video for more.
 
   Home   Help Search Calendar Login Register  
FE-FC Holden Discussion Forum > General > General Board (Moderators: RET, Glenn 'Stinky' Stankevicius) > Engineer's report
Pages: [1]   Go Down
« previous next »
  Add bookmark  |  Print  
Author Topic: Engineer's report  (Read 1412 times)
Liam Moloney
Guest
« on: May 09, 2002, 06:21:13 AM »
0
Im am very close to RWC with my Fe and i am wondering if any one has had to get an engineers certificate with a 173 trimatic. If anyone has latley, what exactly did you need ie. 2 speed wipers, warning lights in dash, brakes, i have done most of the requrements but i am not sure what else i need to do.

Roll Eyes
Thanx Liam
Logged
yackboy49
Junior Member
**
Offline Offline

Model: FC
Posts: 88

EARLY HOLDEN CAR CLUB INC. WANGARATTA


View Profile
« Reply #1 on: May 09, 2002, 06:46:06 AM »
0
Liam,
my  Engineers report was done for NSW rego by  Enkelman & assoc. e-mail address  info@enkelman.com.au... requirements were;
2 speed wipers with a washer system,effective heater demister, two external rear view mirrors,ELR - lap/ sash seat belts ( approved GM assemblies, manufactured by Rainsford. emission test, with confirmed idle CO at less than 4.5%, exhaust noise level, road tested for braking.
plus normal things like width of rims, clearnace etc.
Regards  Phil.
Logged
Phil
Pages: [1]   Go Up
  Add bookmark  |  Print  
« previous next »

Share this topic...
In a forum (BBCode) 
In a site/blog (HTML)

 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.036 seconds with 20 queries.